6 PORT DIVERTER / SELECTORVALVE 40 - 60 Lt/Min 3000 PSI 3/8" or 1/2" in 12-24V DC HYDRAULIC

6 Port Hydraulic Diverters / Selector valves are a simple cost-effective way to add an additional alternative Hydraulic Function to a machine e.g. a double acting cylinder, Reversible drive motor or another valve.

Please note; when making one function into two, only one function will work at a time.

Six port solenoid diverters allow two separate double-acting circuits to be controlled from one directional flow control valve. Valves can also be installed closer to where the new function is required thus saving in time and additional hose fittings and materials.

We do have TWO listing for these items. This listing is for 'Closed' centre diverters only. Having an 'Open' centre simply make it easier for the Coil/Solenoid to change direction under higher pressures. These also have a push in manual overide.

Please see the other 6 port listing for the 'Open' centre choice. 3/8" size only

Comes with 3/8" or 1/2" BSPP ports flow 40 - 60 Lt/Min, at to 3000 PSI, 12 or 24 V DC solenoid coil Square plug with indicator light,

P1 & P2 are pressure in, C2 & C3 are normally open functions, & C1 & C4 are the alternative function when solenoid coil is energised.

The 3/8" ported unit is with closed centers

The 1/2" ported model is with closed centers only .

Directions for use.

The 3/8" BSPP port model is capable of flowing 40 Lt/Min.

If used with oil at less than 150 bar (2250 PSI) pressure then no case drain is required.

It is capable of pressures up to 250 bar 3600 PSI.

The 1/2" BSPP ported unit will flow up to 60 Lt/Min at a max of 315 bar / 4725 PSI pressure.

Please note, over 2250 PSI (150 bar) oil pressure the 1/2" ported unit requires a low pressure case drain. There is a 1/4" BSPP port on the end or the side for this purpose.

Case drain is for draining away any internal leakage, rather than pressurise the valve.

Case drains must return directly to tank.

For wiring, just use the two terminals opposite each other, ignore end terminal

These divertors are also 'stackable' (see photos) . These means you could stack eg. 3 x 6 port diverters to achieve four different functions.

Buy with Confidence from a long established Hydraulic Service Center get a

12 month warranty and an ' Australian Tax Invoice.

3/8" ,No drainline up to 160 bar (2400 psi)(, above this up to a maximum of 250 bar / 3750psi the drainline must be connected.
1/4" , Drainline required at all times. All come with manual overide should power fail. Designed to be used in applications where the flow and return from a control valve is used to operate two separate circuits.

We carry a full range of hydraulic fittings, adaptors & hosing. Please call us on 07 55631982 or email us at hosefixersaustralia@gmail.com with any questions

Call us on 0755 631982 with any questions you may have or for a different filter port size or micron .

IMPROPER SELECTION, INSTALLATION, IMPLEMENTATION AND/OR OPERATION BY ANYONE OTHER THAN PERSONS WITH APPROPRIATE TECHNICAL AND MECHANICAL TRAINING CAN RESULT IN DAMAGE TO EQUIPMENT OR PROPERTY, SERIOUS PERSONAL INJURY OR DEATH. PROPER PRECAUTIONS AND SAFETY PROCEDURES SHOULD BE IMPLEMENTED PRIOR TO INSTALLATION AND OPERATION OF EQUIPMENT.

RL$ 24.11-2021